Geyser Blanket | Walco Power Solutions

By: Walco Power  11-11-2011

A Geyser Blanket supplies an additional layer of insulation for existing geyser installations; it is designed to be wrapped around the geyser.

What makes our Geyser Blanket superior is the fact that it is made up of a 15 to 20mm layer of Heat resistive and weatherproof bubble formed plastic insulation with a reflective foil sheeting cover on one side.

Our Geyser Blanket will provide an average saving of approx. 12% on the electricity portion used by the geyser.

It is a DIY system with enough covering material for a 200 litre geyser plus piping coverage.

Price tag:
R 750.00 (incl Vat)

For inquiries contact us now!


Other products and services from Walco Power

11-11-2011

Products | Walco Power Solutions

The Walco Power Solution for this problem is a combination of energy saving devices that has been designed to prevent your geyser from heating up water when it is not required but still keep the water hot enough for constant use. Unlike a timer, the device will wait until you have finished using hot water, then it will allow the water in the geyser to reach its maximum temperature again before regulating the flow of current.


11-11-2011

Combo Kit | Walco Power Solutions

The solution can decrease your electricity consumption by up to 25% or more under correct usage, saving you money while still allowing you to enjoy hot water 24 hours a day. These devices has been designed to prevent your geyser from heating up water when it is not required but still keep the water hot enough for constant use. Study, Design, Controls, Installation and Commissioning according to your requirements.


11-11-2011

Power Buddy | Walco Power Solutions

The intelligent technology optimizes the voltage and current demands thus reducing the active power / KWH demands and achieves around 10-20% saving on your electricity bill. The principle of operation is limited to inductive loads and will give a power saving according to the amount of inductive loads operating in a particular installation.


11-11-2011

Geyser Master | Walco Power Solutions

These calculations are fed into a 100 Hr battery back up timer outside the peak hour periods which then drives a high current protection contactor which will supply electricity to the heating element via the thermostat. The Geyser Master has been tested over the past 12 years in various areas in South Africa from Cape Town to Pretoria.


11-11-2011

Energy Saving Lights | Walco Power Solutions

No Warm up time required – Instant Start. 65 % Reduction in Energy Consumption. HIGH/LOW BAY Energy Saving Lights. Ballast Life – 20 to 40000 hours.