DT800 High Speed Data Logger

By: Measurement & Control Solutions  11-11-2011
Keywords: Data Storage, Data Acquisition, Data Logging

  • • High Speed Data Acquisition

  • • Stand Alone and real Time Monitoring

  • • Up to 42 Analogue Sensors Inputs

  • • 16 digital channels

  • • Low voltage AC inputs

  • • ATA Flash Card for Removable Data Storage

  • • Serial Sensor Channel

  • • Fatigue Cycle Counting

Combining the roles of data acquisition, data logging and controller, the DT800 is a robust, stand alone, high speed unit featuring 16 bit resolution, battery backed internal SRAM and ATA Flash memory card support, 12V or internal battery operation

Versatile Measurement

The DT800 has 42 analogue inputs, giving 42 separate single ended channels or 24 differential channels. These are isolated and over voltage protected, with measurement across 12 autoscaling ranges from 10mV to 13V full scale.

All common measurement types are supported, including DC and AC(RMS) voltage, current, resistance, temperature, bridges, strain gauges, 4-20mA loops and frequency. Adjustable excitation and triggering are provided on all channels. A Serial Sensor Port is also included for sensors with RS232/485 or SDI-12 capability.

Digital I/O consists of 8 digital input channels, and 8 digital I/O channels. Two of the digital inputs have adjustable threshold for the monitoring of low level signals. Digital state, counts at up to 10kHz and triggering are supported on all digital channels.

Data Storage and Communications

An RS232 port, an Ethernet port and a Flash card port are provided as standard for dataTaker programming and data retrieval. Data can either be returned in real time or stored to internal RAM or a memory card.

The DT800 has modem dial-in and dial-out capability. TCP/IP is supported, which means that the DT800 can communicate over a local area network. In addition, an on-board FTP server is provided so that files can easily be transferred via the Ethernet or RS232 ports.

Keywords: Data Acquisition, Data Logging, Data Storage, Serial Sensor

Contact Measurement & Control Solutions

Email

Print this page

Share

Other products and services from Measurement & Control Solutions

11-11-2011

dataTaker - CEM20 Channel Expansion Modules

Incorporating the same dual isolation technology as the DT80 range dataTaker data loggers each channel of the CEM20 can be used for two isolated inputs or three common reference inputs so the maximum inputs increases further. Increasing the channel capacity of the dataTaker DT80 range is made very easy by adding dataTaker Channel Expansion Modules. Analogue and control cables for connection to the dataTaker data logger are included as standard.


11-11-2011

DT80 General Purpose Data Logger

With support for multiple SDI-12 sensor networks, Modbus for SCADA systems, FTP and Web interface, 12V regulated output to power sensors, the DT80 is ready to be rolled out into environmental, industrial and many other types of monitoring projects. Analog and digital channels, high-speed counter inputs, phase encoder inputs and programmable serial sensor channels allow the DT80 to easily connect to most sensors and data measurement sources.


11-11-2011

DT85 General Purpose Data Logger

With support for multiple SDI-12 sensor networks, Modbus for SCADA systems, FTP and Web interface, 12V regulated output to power sensors, the DT85 is ready to be rolled out into environmental, industrial and many other types of monitoring projects. Analog and digital channels, high-speed counter inputs, phase encoder inputs and programmable serial sensor channels allow the DT85 to easily connect to most sensors and data measurement sources.


11-11-2011

dataTaker - DT80G Geotechnical Data Logger

The dataTaker GeoLoggers can monitor a wide variety of geotechnical datalogging applications including slope stability, subsidence, dam wall monitoring, tunnel and mining excavation, ground water, tunnel wall monitoring and site assessment.