dataTaker - CEM20 Channel Expansion Modules

By: Measurement & Control Solutions  11-11-2011
Keywords: Data Logger, Data Logging, Data Loggers

  • • Turns one analogue channel into 20

  • • Cost effective

  • • Compact size

  • • Ultra low power

  • • Compatible with DT80 & DT85 series loggers (series 2 and later)

  • • Solid construction and design

Increasing the channel capacity of the dataTaker DT80 range is made very easy by adding dataTaker Channel Expansion Modules (CEM20). Each CEM20 connects 20 universal data logging channels to the dataTaker data logger.

Increased Channel Capacity

A dataTaker CEM20 connects to one analogue channel of the dataTaker data logger. This effectively expands the total channel capacity of the DT80 to 320 analogue inputs and the DT85 to an incredible 960 inputs. Incorporating the same dual isolation technology as the DT80 range dataTaker data loggers each channel of the CEM20 can be used for two isolated inputs or three common reference inputs so the maximum inputs increases further.

Easy Setup and Connection

Connecting a channel expansion module to a dataTaker data logger is very easy. The CEM20 is powered directly from the dataTaker data logger 12V output. Analog output connections of the CEM20 connect to a analog channel of the data logger.

Analogue and control cables for connection to the dataTaker data logger are included as standard.

Keywords: Channel Expansion, Data Logger, Data Loggers, Data Logging, Expansion Modules,

Contact Measurement & Control Solutions

Email

Print this page

Share

Other products and services from Measurement & Control Solutions

11-11-2011

DT80 General Purpose Data Logger

With support for multiple SDI-12 sensor networks, Modbus for SCADA systems, FTP and Web interface, 12V regulated output to power sensors, the DT80 is ready to be rolled out into environmental, industrial and many other types of monitoring projects. Analog and digital channels, high-speed counter inputs, phase encoder inputs and programmable serial sensor channels allow the DT80 to easily connect to most sensors and data measurement sources.


11-11-2011

DT800 High Speed Data Logger

An RS232 port, an Ethernet port and a Flash card port are provided as standard for dataTaker programming and data retrieval. These are isolated and over voltage protected, with measurement across 12 autoscaling ranges from 10mV to 13V full scale. The DT800 has 42 analogue inputs, giving 42 separate single ended channels or 24 differential channels. A Serial Sensor Port is also included for sensors with RS232/485 or SDI-12 capability.


11-11-2011

DT85 General Purpose Data Logger

With support for multiple SDI-12 sensor networks, Modbus for SCADA systems, FTP and Web interface, 12V regulated output to power sensors, the DT85 is ready to be rolled out into environmental, industrial and many other types of monitoring projects. Analog and digital channels, high-speed counter inputs, phase encoder inputs and programmable serial sensor channels allow the DT85 to easily connect to most sensors and data measurement sources.


11-11-2011

dataTaker - DT80G Geotechnical Data Logger

The dataTaker GeoLoggers can monitor a wide variety of geotechnical datalogging applications including slope stability, subsidence, dam wall monitoring, tunnel and mining excavation, ground water, tunnel wall monitoring and site assessment.