Martec - PRODUCTS - CableCURE

By: Martec  11-11-2011
Keywords: Cables

With the process extruded cable that has suffered water tree damage can be fully restored and further damage prevented.

Is Your Cable a Candidate for CableCURE® Enhancement Service?

When deciding whether to enhance or replace an existing cable, a good place to start is to answer these questions:

• Are we experiencing reliability problems due to failures in stranded, solid dielectric cables?

• Would the disruption to landscaping and pavement caused by replacement be expensive or create public relations or customer satisfaction problems?

• Do we have more problem areas than we have budget to address?

• Would we like to save money with a much more cost-effective approach than replacement?

If you answered "yes" to any of these questions, CableCURE® treatment is an alternative you should consider.

Turnkey programme:

"Test, Treat, or Replace." This program allows you to maximise your distribution reliability budget by treating all cables that can be treated, then replacing only those that cannot be effectively treated with the CableCURE® process.

Test:

Prior to injection, the crew will do some initial testing that will help your team to make the right decision.

Treat:

By the end of the test process, treatment can commence or planning for replacement of the distribution cable system can start. The distribution system will be either upgraded with treated cable or new cable. This approach insures the most cost-effective use of your budget while also providing for an approach that assures that the entire power system has been addressed. So you maximise your reliability while minimising your costs!

Independent testing has proved conclusively that CableCURE® fluid improves the performance of all solid-dielectric cables by at least 0.5% per day, with peak performance improvements approaching 350% within two years of treatment. We experience success rates of 80-90% at customers. You can count on our warranty. If your cable fails dielectrically after CableCURE treatment, UtilX will refund all of your money for the treated segment or segments of cable that experience failure for up to 20 years after the date of service.

Keywords: Cables

Other products and services from Martec

11-11-2011

Martec - PRODUCTS - products

Motors, generators, compressors, turbines, general. Transformers, electrical panels, fuel tanks. Cables, XLPE MV and HV.


11-11-2011

Martec - SERVICES

Non-intrusive, on-line, periodic condition assessment of cables and accessories. Periodic ultrasonic inspections of bearings, couplings, gears, valves, pumps. Ultrasonic detection of compressed air, steam, gas and vacuum leaks on-line. Seal integrity testing without application of pressure or vacuum. On-line acoustic monitoring of recovery boilers.


11-11-2011

Martec - PRODUCTS - Acoustic Monitoring Systems

Triple 5’s On Line Systems, Bench Top and Portable leak detecting equipment will help you locate problem areas in the early stages before they grow too large causing longer down times, higher repair costs and possible harm to employees. Advanced technology is employed to locate leaks in all areas of the boiler including the furnace, waterwall, superheat, reheat, economizer, penthouse, and feedwater heaters.


11-11-2011

Martec - PRODUCTS - CableWISE

Knowing a cable system’s weaknesses enables owners, asset managers and reliability engineers to be proactive in finding and fixing problems before they cause outages. Applicable to all types – PE, XLPE, EPR, PILC and other power cables operating at all voltages - 5kV to 345kV including mixed services. A detailed report with findings and recommendations will be forwarded to the customer.


11-11-2011

Martec - PRODUCTS - Demagnetisers

The cause of the magnetic fields can be traced to magnetic chucks and couplings, magnetic particle inspections, magnetic probes and mounts, welding and other sources of electrical currents such as static currents or lightning. Demagnetizing is a necessary preventive maintenance procedure for rotating machinery to remove unwanted magnetism and reduce the risk of shaft currents being generated from high residual magnetic fields.